How do you size a new furnace?

We perform a Manual J heat loss calculation and verify duct capacity (static pressure) so the blower can deliver the required airflow quietly and efficiently.

80% vs. 90%+ furnaces—what’s the difference?

90%+ (condensing) furnaces vent in PVC and produce condensate that must be drained and often neutralized; they’re typically more efficient and quieter. 80% units use metal venting and rely on chimney or dedicated venting.

Do you handle permits and inspections?

Yes. We install to code, pull permits where required, and provide commissioning documentation at inspection.

How long does installation take?

Most single-system installs finish in one day. Duct modifications, chimney liners, or accessory add-ons may extend the timeline.

Wayne, NJ • Heating

Furnace Installation

Your home’s comfort and safety depend on a furnace that’s sized correctly and installed by the book. We design and install gas and electric furnaces with proper venting, gas/electrical, and commissioning so you get quiet, efficient, and reliable heat.

What You Get with a Proper Install

Load calculation (Manual J) to right-size BTUs for your home.

Duct evaluation — static pressure checks and return sizing for quiet airflow.

Venting & combustion safety — chimney liner or PVC terminations for condensing units.

Gas & electrical — correct pipe sizing, shutoffs, drip legs, dedicated circuit, and disconnect.

Condensate management — traps, neutralizer media (condensing), pumps, and overflow safeties.

Commissioning — combustion analysis, temp rise, blower setup, and control configuration with documentation.

Comfort Options

Two-stage or variable-speed furnaces for even temperatures and quieter operation.
Whole-home humidifiers, high-MERV filtration, and UV/polarized air cleaners.
Smart thermostats and zoning for better control across floors.

Installation Day — Step by Step

Protect work areas and remove old equipment.
Set/level furnace; connect venting and gas with leak checks.
Wire low/high voltage; install disconnect and surge protection as needed.
Configure drains and safeties; program controls.
Commission: combustion, temp rise, airflow/static pressure, and final walkthrough.