What heating systems do you install?

Gas/electric furnaces, boilers, and heat pumps, including hybrid systems paired with AC or heat pump.

How do you size a new system?

We perform a Manual J load calculation and verify duct capacity (Manual D) or hydronic sizing for boilers.

Do you handle permits and inspections?

Yes. We install to code, pull permits where required, and provide commissioning documentation.

What commissioning do you perform?

Combustion analysis, static pressure/airflow, safety checks, and final performance verification.

Wayne, NJ • Heating

Heating Installation

Comfort starts with a system that’s sized right and installed by the book. We install furnaces, boilers, and heat pumps with careful attention to venting, gas/electrical, and commissioning so you get quiet, efficient, and safe heat for years.

What You Get with a Proper Install

Load & duct/hydronic design — Manual J/D for air systems; proper boiler sizing, circulators, and zoning for hydronic.

Vent & combustion safety — draft/pressure switch validation, PVC terminations for 90%+, clearances to combustibles.

Gas & electrical — correct pipe sizing, shutoffs, drip legs, dedicated circuits, disconnects, and surge considerations.

Condensate management — traps, neutralizers (condensing), pumps, and overflow safeties.

Commissioning — combustion analysis, static pressure, blower setup, control configuration, and documentation.

Permits & inspection — installed to code with inspector walkthrough.

System Options

Furnaces — single/two-stage and variable-speed, up to high-AFUE condensing models.
Boilers — standard and condensing, baseboard, radiator, or radiant applications.
Heat pumps — cold-climate models, hybrid dual-fuel pairings with furnaces.
Comfort add-ons — humidifiers, filtration/IAQ, zoning, and smart controls.

Installation Day — Step by Step

Protect work areas and remove old equipment.
Set/level equipment, connect venting and gas/electrical.
Configure drains and safeties; pressure/combustion checks.
Program controls, verify airflow or hydronic performance.
Finalize commissioning and review operation/maintenance.

After the Install

Plan annual maintenance to protect warranties and efficiency. We note filter sizes, recommended schedules, and any special steps (condensate neutralizer media changes, boiler service intervals).